Ondrives: Linear - Linear Slides - T & T-SS

T & T-SS : 500mm & 1000mm Lengths

Linear » Linear Slides »
T & T-SS : Single Edge Track (Undrilled)

Discounts

1+ 0%

20+ 5%

40+ 10%

60+ 15%

100+ 20%

200+ 35%

Part Number		Length	E	F	G	J	MD_T	Kg/m	Steel			Stainless
Steel	Stainless	Length	E	F	G	J	MD_T	Kg/m	Cost	Quantity	Order	Cost	Quantity	Order
T1-500	T1-500SS	500	11.09	4.74	0.78	1.57	3.17	0.272	£28.99			£58.82
T1-1000	T1-1000SS	1000	11.09	4.74	0.78	1.57	3.17	0.272	£58.01			£117.62
T2-500	T2-500SS	500	15.87	6.35	0.78	2.36	4.75	0.509	£42.70			£85.46
T2-1000	T2-1000SS	1000	15.87	6.35	0.78	2.36	4.75	0.509	£85.42			£170.95
T3-500	T3-500SS	500	22.22	8.71	1.57	2.76	6.35	1.020	£75.05			£150.17
T3-1000	T3-1000SS	1000	22.22	8.71	1.57	2.76	6.35	1.020	£150.10			£300.33
T4-500	T4-500SS	500	26.97	11.09	2.36	3.17	7.92	1.630	£112.79			£225.45
T4-1000	T4-1000SS	1000	26.97	11.09	2.36	3.17	7.92	1.630	£225.58			£450.88

Material
T: AISI 1045 Steel, top contact surfaces hardened 58 Rockwell C minimum, polished, oiled.
T-SS: AISI 400 series Stainless Steel, top contact surfaces hardened 48 Rockwell C minimum, polished, oiled.
Portion below indexing is left soft so it may be drilled for mounting.

Features (General)
•Proven technology/high reliability
•Flexibility and simplicity in design
•Low installed cost
•Smooth, antifriction operation
•Low noise/low vibration
•High speed capacity
•Impervious to contaminated environments
•Long stroke lengths
•Easy installation and maintenance
•Low profile

Features (Track)
•Single edge design allows for flexible track pair spacing.
•Patented mounting shoulder allows for accurate positioning of Vee ways.
•Available induction hardened and polished as standard.
•Induction hardened track remains soft below the mounting shoulder, allowing for drilling or other machining.
•Available undrilled as standard, pre-drilled on request.
•Can be easily butt-joined for stroke lengths exceeding maximum single piece lengths (6096mm). Maximum length available 6096mm (except T4SS maximum length 5790mm). Any length cut to a tolerance of ±1.5mm. (Cutting charge applies.)

Downloads
PDF Documents : Catalogue Page | Technical | Full Range of Dual-Vee™ Slides