Ondrives: Linear - DryLin® R Bearings & Housings - OJUM01 Type : Open Long Drylin® R Slide Bearings

OJUM01 : DryLin® R Slide Bearings - Open Long

Linear » DryLin® R Slide Bearings & Housings »
OJUM01 Type : DryLin® R Slide Bearings - Open Long

OJUM Igubal DryLin Sliding Bearings

Discounts

1+ 0%

6+ 5%

20+ 10%

40+ 15%

60+ 20%

100+ 30%

Part Number	Shaft Ød1	d2 H7	B h10	W^-1	a^+0.1	dn h10	B1 H10	s H10	f^±0.2	H^-0.5	Cost	Quantity	Add to Basket
OJUM01-10	10	19	29	7.3	0.0	17.5	21.6	1.30	0.00	1.2	£31.07
OJUM01-12	12	22	32	9.0	3.0	20.5	22.6	1.30	1.33 (7.0°)	1.2	£32.45
OJUM01-16	16	26	36	11.6	2.2	24.2	24.6	1.30	0.00	1.2	£33.67
OJUM01-20	20	32	45	12.0	2.2	29.6	31.2	1.60	0.00	1.2	£39.87
OJUM01-25	25	40	58	14.5	3.0	36.5	43.7	1.85	-1.50 (-4.3°)	1.5	£56.11
OJUM01-30	30	47	68	16.6	3.0	43.5	51.7	1.85	2.00 (4.9°)	2.0	£67.79
OJUM01-40	40	62	80	21.0	3.0	57.8	60.3	2.15	1.50 (2.8°)	2.0	£94.98
OJUM01-50	50	75	100	25.5	5.0	70.5	77.3	2.65	2.50 (3.8°)	2.0	£176.35

Material
Case: Aluminium
Bearing: DryLin® R. Replacements available.

Performance
Maximum Mean Surface Pressure: 25 N/mm²
Highest Wear Resistance at loads: < 2 N/mm²
Recommended Tolerance for Mating Shaft: h6-h10
Maximum Speed: 8 m/s (dry) >10 m/s (lubricated) 1.5 m/s (rotating dry)
Working Temperature Range: -60°C to +100°C (increased wear when used in excess of 80°C).

Special Features
Enclosed anodized aluminum adapter.
Dimensions corresponding to the standard for recirculating ball bearings.
Recommended housing bore H7.
For use with circlips according to DIN 471 and/or 472 (not included)

Other Info.
Best coefficients of friction are with hard ground shafting 50 HRC 0.2 µm Finish,
but friction figures are only marginally higher for other shafts.
For use with DryLin® R: AWM Type Aluminium Shafts and AWMU Type Supported Aluminium Shafts

Downloads
PDF Documents : Catalogue Page | DryLin® R Technical | Complete DryLin® R Sliding Bearings Range